WiLife V2.5 User Manual
Page 17
Welcome to WiLife
User Guide
9
CAT
5
E
C
ABLE
F
OR
S
TANDARD
W
I
L
IFE
R
ETAIL
K
ITS
The CAT 5e Cable carries DC power from the Camera Power Supply to the camera and provides the network
connection for digital data communications to and from the camera. The cable supplied with the WiLife Indoor
Camera packages was specifically selected because it was small, flexible, and unobtrusive, in comparison to a
typical CAT 5e cable.
Note: You can find longer CAT 5e cable cables in our online store at
www.wilife.com
.
F
OR
W
I
L
IFE
P
RO
K
ITS
The CAT5e Cable carries DC power from the WiLife power injector (single-port or six-port) to the camera and
also allows for the digital data communications over the LAN to the WiLife Command Center.
Note: You can find longer CAT 5e cable cables in our online store at
www.wilife.com
.
P
ATCH
C
ABLES
Component of WiLife Pro kits.
The patch cables provided with all WiLife Pro packages allow you to easily connect the IP-cameras plugged into
the power injector to the router.
R
ECEIVER
Component of the WiLife Retail Master System kits.
The Receiver module provides the interface between the PC and the power line data link. It
communicates with the PC via the USB. The PC sends commands to the cameras to configure
and control them. It receives status from these units, as well as the compressed video streams.
The receiver is not powered by the plug.
USB
C
ABLE
Component of the WiLife Retail Master System kits.
The USB connects the Receiver to your PC allowing the network to communicate with the Command Center
application. It transfers configuration commands to the cameras and receives compressed video streams from
them. Communication with the PC is accomplished using a standard USB 1.1 or 2.0 interface.
C
AMERA
S
UCTION
C
UP
Component of the WiLife Indoor Master System.
Use the large suction cup to hang the Indoor camera on a window. The suction cup connects
to the back or front of the camera. If you screw the suction cup onto the back, the camera's
lens points into the house. If you screw the suction cup onto the front of the camera, the
camera's lens can be directed to monitor a zone outside of the house.
D
ESKTOP
M
OUNT
B
ASE
Component of the WiLife Indoor Master System.
The Desktop Mount Base included in the installation kit is used to place the Indoor camera
on a flat surface such as on a windowsill, bookshelf, or any other place that is flat and
stable.