WiLife V2.5 - Manual (Page 66)

Setting System Options User Guide
52
b) To delete a single zone, left-click anywhere in the zone and then press the Delete key or click the
Clear Selected Zone
button.
c) To delete all zones, click the
Clear All Zones
button.
d) Finally, to detect motion anywhere on the image, click the
Enable Entire Image
button.
Note: Remember, you can create up to 16 motion zones per camera.
Set Motion Detection Sensitivity
Setup > Recording > Motion Detection section > Sensitivity Slider.
Use the Sensitivity slider on the Setup > Recording tab to adjust the level of motion sensitivity for each camera.
The setting ranges from 0 to 100 sensitive. 100 is the most sensitivity. You can adjust the sensitivity to meet
your needs. A very low number will tell the camera to only detect the motion of large objects (a person or car). A
high number will increase the sensitivity allowing you to capture the motion of small objects like pets or even a
passing cloud.
In our graphic below, the motion detection sensitivity level is set to 50.
Schedule Recording Time
Setup > Recording > Recording section > SCHEDULE RECORDING TIME .
The Command Center allows you to schedule recording events for each camera. These events have two types:
Set Continuous Recording and Turn Cameras and Recording Off.
During Continuous recording schedules, Command Center records video from the selected camera even when
there is no motion. Turn Cameras and Recording Off schedules disable both Motion and Continuous recording,
although you can still monitor live video.
To activate the Recording Schedule dialog, click the
SCHEDULE RECORDING TIME
button on the Setup >
Recording tab.
See Chapter 6: Using the Scheduler for more information.