Oven cleaning instructions, Preparation, Frequency – Wells OC-2HG User Manual

Page 14: Tools, Daily cleaning, Caution

Advertising
background image

OVEN CLEANING INSTRUCTIONS

12

PREPARATION

Allow oven to cool to 150ºF or less

FREQUENCY

Daily

TOOLS

Fiber Brush,

Mild Detergent, Sanitizer

Clean

Towel

DAILY CLEANING


1. Turn POWER SWITCH to FAN. With the door held open, allow the

oven to cool. When the oven interior has cooled to 150ºF or less,

turn the POWER SWITCH to OFF.


2. Remove racks and rack supports. Remove fan baffle.


3. Brush the fan wheel and wipe it with a moist cloth. Sponge out all
loose

particles.


4. Wipe down the entire interior using a clean cloth moistened with

hot water and a mild detergent. Rinse by wiping with a clean towel

moistened with sanitizer.


IMPORTANT: Always wipe or rub in the direction of the polish

lines or grain of the metal.


5. Clean oven racks and rack supports in a sink or dishwasher.


6. Reinstall the fan baffle, paying particular attention that the lip on

the right side of the fan baffle is fully seated in the slot in the edge

of the oven cavity. Reinstall rack supports and racks.


IMPORTANT: Take care to avoid damage to fan blades when

reinstalling fan baffle.


7. Turn power switch to FAN . Verify that fan runs smoothly and does

not contact fan baffle. Turn power switch to OFF. Reposition fan

baffle if necessary.


8. Wipe down the prep top and exterior of the oven using a clean

cloth moistened with hot water and a mild detergent. Rinse by

wiping with a clean towel moistened with sanitizer.


IMPORTANT: Always wipe or rub in the direction of the polish

lines or grain of the metal.


9. Replace oven rack supports. Leave the door open overnight.

PROCEDURE IS COMPLETE

CAUTION:

ELECTRIC SHOCK
HAZARD

Disconnect appliance
from electric power before
cleaning.


CAUTION:

BURN HAZARD

Allow appliance to cool
completely before cleaning.
Do not attempt to clean the
oven until it has cooled to
150ºF or less. It can burn
you. Hand protection is
required.


CAUTION:

CUT HAZARD

FAN BLADES ARE SHARP.
Use due care when cleaning
and/or wiping.

IMPORTANT: DO NOT spill
or pour water into controls,
control panel or wiring.


Damage to internal
components from water
damage is not covered by
warranty.

DANGER

ELECTRIC SHOCK HAZARD

DO NOT SPRAY WATER ON OR AROUND

ELECTRICAL EQUIPMENT

DO NOT WASH FLOOR NEAR ELECTRICAL

EQUIPMENT WITH WATER SPRAY

272

304

621

Op

M

OC-2HG

Combo Cook Center

Advertising