Caution – Wells OC-2HG User Manual

Page 9

Advertising
background image

7

Refer to the nameplate on the front of the appliance.
• Verify the ELECTRICAL SERVICE POWER.
• Voltage and phase must match the nameplate specifications, and

available electrical service amperage must meet or exceed the
specifications listed on page 1.

• Wiring must be no less than 4 AWG solid copper wire, rated for at

least 90ºC.


NOTE: Wire gauge, insulation type and temperature rating , as well as
type, size and construction of conduit, must meet or exceed applicable
specifications of local codes and of the National Electrical Code.


1. Electrical connection terminal block and ground lug are accessible

by removing the right side panel.


2. This appliance must be connected to a suitable building ground.

The equipment ground connection is marked " ".



3. The appliance is shipped from the factory wired for 3-phase

electrical service. Refer to the Wiring Diagram included with this

appliance, and verify that field wiring conforms to this diagram.


IMPORTANT: This appliance is not approved for 1Ø operation.

Conversion of this appliance to single-phase operation will void the

warranty.


4. Reinstall right side panel at completion of electrical hook-up.

CAUTION:

RISK OF
DAMAGE

DO NOT connect or energize
this appliance until all
installation instructions are
read and followed. Damage
to the appliance will result if
these instructions are not
followed.

CAUTION:

ELECTRICAL
SHOCK HAZARD


The ground lug of this
appliance must be connected
to a suitable building ground.


IMPORTANT:
Contact a licensed electrician
to install and connect
electrical power to the
appliance.


IMPORTANT:
Damage due to being
connected to the wrong
voltage or phase is NOT
covered by warranty.

IMPORTANT:
The appliance is shipped
from the factory wired for
3-phase (3ø) electrical
service. This appliance is not
approved for 1ø operation.
Conversion of this appliance
to single-phase operation will
invalidate the UL listing and
void the warranty

INSTALLATION (continued)

DANGER: ELECTRICAL SHOCK HAZARD

ELECTRICAL CONNECTIONS MUST BE MADE BY A

LICENSED ELECTRICIAN

Electrical shock will cause death or serious injury.

272

304

621

Op

M

OC-2HG

Combo Cook Center

Advertising