Rs232 port configuration menus – Western Telematic APS-16 User Manual
Page 23
5.5.3.
RS232 Port Configuration Menus
The Port Configuration Menus are used to select options for each of the APS RS232 ports.
Parameters selected via these menus will stay in effect until the unit is initialized or the /P
command is used to reconfigure the port. After initialization, parameters will revert to the
defaults specified by the SetUp Switches.
To select port parameters, proceed as follows:
1. Access the Command Mode. If the password prompt is displayed, key in your Supervisor
Level Password.
2. Type /P, followed by the number of the port to be configured, and press [Enter]. For
example, to configure Port 2, type /P 2 [Enter]. The Port Configuration menu will
appear (Figure 5.1).
a) If the /P Command is entered without the port number (e.g. /P [Enter]), the
configuration menu for your resident port will be displayed.
b) The /P command is only available in the
Supervisor Mode
5-5
APS Series - Asynchronous Port Switches, User's Guide
Configuration
PORT PARAMETERS #02
1.
Port Name:
(undefined)
2.
Password:
(undefined)
3.
Baud Rate:
9600
4.
Bits/Parity:
8-None
5.
Stop Bits:
1
6.
Handshake Mode:
CTS/RTS
7.
Port Mode:
Any-to-Any
74.
DTR Output:
Pulse
8.
Supervisor Mode:
Permit
9.
Logoff Character:
^X
10.
Sequence Disconnect:
One Character
11.
Timeout Disconnect:
Off
12.
Response Type:
Verbose
13.
Command Echo:
On
14.
Accept Break:
Yes
Enter:
"<" Previous Port,
">" Next Port,
<ESC> Exit ...
Figure 5.1: Port Configuration Menu (Port 2 Shown)