Western Telematic APS-16 - Manual (Page 45)

/C Connect
Establishes a bi-directional connection between two ports. For more information and command
line examples, please refer to Section 7.1. There are two different types of port connections:
· Resident Connect: If the /C command specifies one port name or number, your resident
port will be connected to the specified port.
· Third Party Connect: If the /C command specifies two port names or numbers, the unit
will connect the two ports indicated. A Third Party Connect command must be issued from
a third port with “Supervisor” command capability. "User" ports cannot initiate a Third
Party Connect.
Note:
• Ports with "User" command capability can only connect to ports that share the
same Port Password.
• Ports with “Supervisor” command capability are allowed to connect to all other
ports.
Availability: Supervisor / User
Format: /C <x> [x] [Enter]
Where x is the number or name of the port(s) to be connected.
Response:
Verbose: Connected xx, when a Resident Connection is initiated, the APS will also display
the currently selected Resident Disconnect Sequence for your port.
Terse: 1
/CP Copy RS232 Port Parameters
Allows quick set-up when all APS RS232 ports will be configured with the same or similar
parameters. When the /CP command is invoked, the APS will display a menu that is used to
select common port parameters, which can then be copied to all APS RS232 ports. For more
information, please refer to Section 5.6.
Availability: Supervisor Only
Format: /CP [Enter]
Response: Displays Copy Parameters Menu
9-5
APS Series - Asynchronous Port Switches, User's Guide Command Reference Guide