Western Telematic APS-16 - Manual (Page 27)

13. Command Echo: Enables or Disables the command echo for this port. (Default = On).
14. Accept Break: Determines whether the port will accept breaks received from the
attached device, and pass them along to a connected port. When enabled, breaks received
at this port will be passed to any port that this port is connected to, and sent along to the
device connected to the other port. When disabled, breaks will be refused at this port,
and hence, not sent to the other port. (Default = Yes)
5.6. Copying Parameters to All Ports
The /CP command (Copy Port Parameters) provides a convenient means for selecting similar
parameters for all APS RS-232 ports.
When the /CP command is invoked, the unit will display a menu which allows you to select
port communication parameters, then copy them to all APS RS-232 ports. The Copy Port
Parameters menu can be used to set all parameters for all RS-232 Ports, or define only a select
group of parameters and then copy them to all ports.
Notes:
• The /CP command is only available in Supervisor Mode.
• The Copy Port Parameters Menu will not display the Port Password. This field
will read either “undefined” or “defined”, depending upon whether or not the Port
Password has been specified.
• The /CP command cannot be used to set Ports 1 and 2 to Passive Mode or Buffer
Mode (Port Mode, Item 7).
• The /CP command cannot be used to disable the Supervisor Mode at Ports 1 and 2
(Supervisor Mode, Item 8).
5-9
APS Series - Asynchronous Port Switches, User's Guide Configuration
COPY PORT PARAMETERS:
1. Port Name:
2. Password: (undefined)
3. Baud Rate:
4. Bits/Parity:
5. Stop Bits:
6. Handshake Mode:
7. Port Mode:
74. DTR Output:
8. Supervisor Mode:
9. Logoff Character:
10. Sequence Disconnect:
11. Timeout Disconnect:
12. Response Type:
13. Command Echo:
14. Accept Break:
(Note: Ports 1 & 2 will NOT have restricted values changed.)
Enter: Parameter # <CR> to define parameter value to copy to all ports,
-<CR> to remove all values set,
X<CR> to exit WITHOUT copy,
<ESC> to copy to all ports and exit ...
Figure 5.3: The Copy Port Parameters Menu