weber 5500 - Manual (Page 18)

18
Step 5
Assemble the frame
You will need: left frame, right frame, two nylon
washers, two 1/4-20 x 1/2 inch bolts and a 7/16 inch
wrench.
Note - Work on carpeted area (on grass, or on one of
the boxes) to protect the finish during frame assembly.
Put the frame pieces so the leg tabs are up. Put the right
frame to your right and left frame to your left. Figure 6.
Slip the two frame halves together with the tabs inside,
until the tabs of the right frame are inside the left frame
and the holes align. Figure 6 (a).
Slip washers over bolts; insert and tighten bolts. (If you
try to insert a bolt and there are no holes, you have the
left frame turned the wrong way. Turn the left frame
around.) Figure 6 (b).
(a)
Left frame
Leg tabs
Frame tabs
Right frame
Figure 6
(b)
Step 6
Continue frame assembly
You will need: frame assembly, two upright frames, front
panel, four 1/4-20 x 1/2 inch bolts, four nylon washers and
a 7/16 inch wrench.
Assemble one upright frame onto the leg tabs of the right
frame, and the second upright frame onto the leg tabs of
the left frame. The tabs must be on the inside of the
frames when the joints are closed. Add front panel with
the large hole down and to your right. Add front panel
with the hole down and to your right. Add washers and
bolts to the left frame/upright frame joint. Tighten. Add
washers and bolts to the right frame/ upright frame joint.
Only start these bolts.
Only start
this bolt
Dimples to
the inside
Only start
this bolt
Figure 7
(a)
(b)