weber 5500 - Manual (Page 29)

29
Step 27
Install left hand swing table
You will need: swing table end bracket, two 10-24 hex
nuts, two 10-24 x 1 3/4 inch machine screws, left hand
slide bar assembly, swing table, four nylon washers,
screwdriver and pliers.
Allow the slide bar to hang down. Push the support rod
into the lower support bracket. Figure 35 (a). Swing the
rod up so you can slide the rod all the way inside the
locking tab. Figure 35 (b). The rod should swing freely
inside the locking tab. Figure 35 (c).
Figure 35
(a)
(b) (c)
Support rod
Slide bar assembly
Slot in frame
(view from below)
Insert one end of the hinge rod into the hole in the
frame. Figure 36 (a).
Insert the other end into the hole in the swing table end
bracket. Figure 36 (b). Hold the end bracket at an angle so
the lower tab is inside the frame tube. Push the bracket into
the frame. Check to see that the lower tab of the bracket is
hooked in the slot in the frame. Figure 36 (c).
To fully seat the bracket, you may have to tap it lightly with a
hammer.
ƽWARNING: If swing table end bracket is in any
way cracked or damaged, do not use swing table.
Call our Customer Service Center to order a new
part.
ƽWARNING: The load limit for the swing table is
30 pounds.
Figure 36
(c)
View from rear
of barbecue
Hinge rod
(b)
(a)