weber 5500 - Manual (Page 33)

33
Step 31
Install the control panel, burner control knobs,
FlameCheck button and tool holders
You will need: control panel, three burner control knobs,
FlameCheck button and three tool holders.
Hook the tool holders over the frame rail. Figure 47.
Set the control panel in place over both frame braces.
(Hold the Crossover Ignition button up while setting the
control panel in place.) Place your thumbs over the
control panel push-in buttons, and push them into the
frame brace until they snap into place. Figure 47 (a).
Push on the burner control knobs and FlameCheck
button. Figure 47 (b).
Hole in frame brace
Figure 47
(a)
(b)
Control panel
push-in buttons
Tool holders
Step 32
Secure the side burner
Pull the right hand swing table up. Stand to the right side
of the barbecue. Slightly pull back both side burner
locks. Slide the side burner toward the control panel.
The locks will snap into the slots in the front and back of
the side burner. Figure 48.
ƽCaution: Make sure both locks have snapped
into place.
View from above
View from side
Figure 48