Windows Marketplace V.90 - Manual (Page 55)

55
Bits 4-6 result codes (Xn)
0 = X0 selected
4 = X1 selected
5 = X2 selected
6 = X3 selected
7 = X4 selected (Default)
Bit 7 Pulse dial make/break ratio (&Pn)
0 = 33/67 make/break ratio (&P1, &P2) (Default)
1 = 39/61 make/break ratio (&P0)
Default: 112 (01110000b)
S24 Timer to Control Sleep Mode
This command displays the number of seconds of inactivity (no characters sent
from the DTE, no RING) in the off-line command state before the modem places
itself into standby mode. A value of zero prevents standby mode.
Note: If a number between 1 and 4 is entered for this register, it will set the value
to 5, and the inactivity before standby will be 5 seconds. This is done for compat-
ibility with previous products which allowed time-outs down to 1 s.
Range: 0, 5-255
Default: 10
S28 V.34 Modulation Enable/Disable
This register enables/disables V.34 modulation.
0 = disabled, 1-255 = enabled,
Range: 0-255
Default: 1
S30 Inactivity Timer
S30 specifies the length of time (in minutes) that the modem will wait before
disconnecting when no data is sent or received. This function is only applicable to
buffer mode.
Range: 0-255
Default: 0
Units: minutes