Weider WESY91080 - Manual (Page 11)

11
22. Attach the 3 1/2Ó Pulley (15) and a Cable Trap (66) to
the two ÒIÓ-plates (81) with a 3/8Ó x 2Ò Bolt (12) and a
3/8Ó Nylon Locknut (21).
Make sure the Cable Trap (66) is positioned as
shown.
Route the Short Cable (23) around the Pulley (15)
attached to the ÒIÓ-plates in the direction shown.
Route the Short Cable (23) through the first 3 1/2Ó
Pulley (15) on the weight support arm (A).
22
21. Move to the other side of the unit. Route the Short
Cable (23) around the ÒVÓ-Pulley (6) on the Right
Butterfly Arm (48). Make sure the Long Cable Trap
(50) is positioned as shown.
Tighten the Bolt and Locknut on the pulley bracket
(D).
Tighten the Bolt and Locknut on the pre-assembled
Pulley (15) attached to the pulley bracket (D). Route
the Short Cable (23) around the Pulley in the direc-
tion shown. Make sure the Long Cable Trap (50) is
positioned to hold the Cable in place.
21
20. Locate the Short Cable (23). It has a ball on one end
and a threaded tip on the other.
Feed the threaded end of the Short Cable (23)
between the pre-assembled 3 1/2Ó Pulley (15) and the
hook (C) on the Top Frame (55). Next, route the Short
Cable around the angled ÒVÓ-Pulley (6) on the
Butterfly Upright (42) and then around the ÒVÓ-Pulley
(6) on the Left Butterfly Arm (47).
Make sure the Long Cable Trap (50) is positioned
to hold the Cable in place. If necessary, adjust the
position of the Long Cable Trap.
20
55
23
15
C
47
6
50
42
50
6
48
15
D
15
15
A 23
23
19. Attach two 3 1/2Ó Pulleys (15) to the weight support
arm (A) on the Top Frame (55) with two 3/8Ó x 2Ó
Bolts (12) and two 3/8Ó Nylon Locknuts (21).
19
21
15
12
55
A
81
21
81
12
66