Weider WESY91080 - Manual (Page 5)

1. Before beginning, be sure that you have read and
understood the information on page 4.
Locate and open the parts bag labeled ÒFRAME
ASSEMBLY.Ó
Press a 2Ó Square Cover Cap (78) onto each end of
the Stabilizer (5).
Insert two 3/8Ó x 2 3/4Ó Carriage Bolts (94) up through
the Stabilizer (5) and place it flat on the floor.
1
2. Press a 2Ó Square Inner Cap (27) into the end of the
Butterfly Base (4).
Insert two 5/16Ó x 2 1/2Ó Carriage Bolts (1) up through
the Butterfly Base. Secure the Carriage Bolts with
pieces of tape (A) to prevent them from falling out.
Place the Butterfly Base (4) on the floor with the
holes in the mounting bracket over the Carriage Bolts
in the Stabilizer (5).
3. Insert four 5/16Ó x 2 1/2Ó Carriage Bolts (1) up
through the Press Base (51) and secure them with
tape.
Place the Press Base (51) on the floor with the holes
in the mounting bracket over the Carriage Bolts in the
Stabilizer (5).
Note: The mounting bracket on the Press Base (51)
should be on top of the mounting bracket on the
Butterfly Base (4).
4. Insert two 3/8Ó x 2 3/4Ó Bolts (93) through the holes in
the two mounting brackets and the Stabilizer (5).
Hand tighten four 3/8Ó Nylon Locknuts (21) onto the
four Bolts in the mounting brackets and Stabilizer.
Do not tighten the Nylon Locknuts yet.
2
3
4
5
Frame Assembly
78
78
94
5
27
4
1
5
A
1
1
51
5
5
93
21
21
4