Weider WESY91080 - Manual (Page 15)

15
35. Locate and open the parts bag labeled ÒSeat
Assembly.Ó
Attach the Backrest (41) with the name decal to the
Press Upright (56) with two 1/4Ó x 2 1/2Ó Screws (43)
and two 1/4Ó Flat Washers (10).
35 Seat Assembly
33. Remove the 3 1/2Ó Pulley (15) from the Long ÒUÓ-
Bracket (57).
Route the Medium Cable (86) around the Pulley in
the direction shown.
Re-attach the Pulley to the Long ÒUÓ-Bracket (57) with
the 3/8Ó x 2Ó Bolt (12) and the 3/8Ó Nylon Locknut
(21). Make sure the Cable Trap (66) is positioned
as shown.
33
15
57
66
86
41
43
10
43
10
34. Attach the closed loop on the end of the Medium
Cable (86) to the Top Frame (55) with a 5/16Ó x 2 3/4Ó
Bolt (11), a 5/16Ó Flat Washer (8) and a 5/16Ó Nylon
Locknut (3).
Make sure the flat side of the closed loop is
turned towards the Top Frame.
34
3
8
11
86 55
56
21
12
36. Insert the 1/4Ó x 2 1/2Ó Carriage Bolt (91) into the cen-
ter hole in a Seat Plate (37). Attach the Seat Plate to
a Seat (13) with two 1/4Ó x 3/4Ó Screws (18).
Insert the 1/4Ó x 2 1/2Ó Carriage Bolt (91) into the indi-
cated hole in the Press Seat Frame (77). Tighten a
1/4Ó Nylon Locknut (2) with a 1/4Ó Flat Washer (10)
onto the Carriage Bolt.
36
13 91
37 18
2
10 77