Preparing the wine cellar – WhisperKool 2500 User Manual

Page 9

Advertising
background image

Page 7

The performance and life of your WhisperKOOL unit is contingent upon the

steps you take in preparing the wine cellar.

Note: Improperly preparing your enclosure or incorrectly installing your WhisperKOOL

unit may cause unit failure, leaking of condensation, and other negative side effects.

IT IS HIGHLY RECOMMENDED THAT YOU OBTAIN THE ASSISTANCE

OF A WINE STORAGE PROFESSIONAL.

Wine storage professionals work with licensed contractors, refrigeration technicians, and racking companies to build

well-insulated, beautiful, and protective wine cellars. WhisperKOOL has put together some useful tips to assist in the

installation process. Our recommendations are meant to act as a guide in the process of building a proper enclosure.

Your intended location may have specific needs that we do not address.

How to Build a Wine Cellar Instructional Video

WhisperKOOL has a construction tutorial available on line at our website: www.whisperkool.com. This tutorial will walk

you through the steps of constructing a properly built wine cellar and the installation of our WhisperKOOL product line.

Wall & Ceiling Framing

Build wine cellar walls using standard 2x4 or 2x6 construction methods and ceiling joists following the guidelines of

local and state codes in your area. As a general rule, the thicker the walls and the higher the insulation value in your

cellar, the better it will be at maintaining a consistent temperature.

Insulation

Insulation is REQUIRED with the use of the WhisperKOOL product. Standard fiberglass or rigid foam insulation is nor-

mally used in cellar construction or, in some cases, “blown-in” insulation is used. It is very important that all walls and

ceilings are insulated to keep the cellar temperature as consistent as possible during the summer and winter months.

The R-value, or quality of insulation, is determined by the rate at which heat passes through the insulation. The

higher the R-value, the more resistant the insulation is to conducting heat. Using higher R-values in insulation will

lower your operating costs and unit run time. (R-13 minimum, R-19 recommended, R-30 for ceiling and exterior walls.)

Vapor Barrier

A vapor barrier is REQUIRED to prevent the intrusion of water vapor so that the cellar can be kept at the correct

temperature and humidity. 6 mm plastic sheeting (recommended) should be applied to the warm side of the cellar

walls. The vapor barrier must also be applied to the outside walls and ceiling. If it is impossible to reach the outside,

then the plastic must be applied from within the cellar. The most common method is to wrap the entire interior, leav-

ing the plastic loose in the stud cavity so the insulation can be placed between each stud. All of the walls and ceiling

must be wrapped in plastic for a complete vapor barrier.

In areas of high humidity, such as Southern and Gulf States, the vapor barrier will prevent infiltration of warm moist

air. The moist air can cause mold to form, and standing water in drain pans promote microbial and fungal growth that

cause unpleasant odors and indoor air quality problems. If mold is found, remove it immediately and sanitize that

portion of the unit.

PREPARING THE WINE CELLAR

Advertising