weber FT 600 - Manual (Page 14)

14
Step 8
Bolt front top frame rail assembly
You will need: two 1/4-20 x 1/2 inch bolts, two nylon
washers, frame assembly and 7/16 or adjustable
wrench.
Slip a washer over the bolt. Insert the bolt from the
inside of the frame assembly into the caster frame.
Figure 10 (a).
Align the hole in the tab of the top frame rail assembly
and start the bolt.
Note: If there are no threads for the bolt to thread into:
a) you may not have the holes of the frame, and top
frame rail tab aligned.
b) the tabs of the top rail may not be to the inside of the
cart. Refer to Figure 7.
Repeat procedure for second bolt. Insert the bolt into
the wheel frame and hand tighten.
Tighten both bolts with 7/16 or adjustable wrench.
Figure 9
Figure 10
(a)
Top frame rail
assembly
Cut out
View from
the back
Tab
Caster frame
Back caster
frame
Caster frame
Back wheel
frame
Wheel frame
Position the top frame rail assembly with the tabs to the
inside of the cart. Figure 9 (a).
Insert the tabs onto the back caster frame and back
wheel frame, the round tubing of the top frame rail
assembly will rest in the cut out portion of the caster
frame and wheel frame.
(a)