weber FT 600 - Manual (Page 19)

19
Step 14
Check burner alignment
Your Weber Gas Barbecue burner assembly has been
factory assembled, pressure and flame tested. As a
safety precaution we recommend you check the burner
alignment. Figure 21.
a) Are the mounting clips that hold the manifold and
burner assembly in place? Figure 21 (a).
b) Do the valves fit into the ends of the burners?
Figure 21 (b).
c) Is the end of each burner inserted into its locating
slot? Figure 21 (c).
Figure 21
(a)
(b)
(c)
Step 15
Set LP fuel scale
You will need: LP tank (empty).
Note - For accuracy, the fuel scale must be set with an
empty tank.
We utilize various LP tank manufacturers. Some of the
tanks we receive have differing top collar assemblies.
(The top collar is the metal protective ring around the
valve.) One series of tanks mounts with the valve
facing front. The other tanks mount with the valve
facing away from the fuel scale. These types of tanks
are illustrated in Figure 22.
Loosen the tank lock wing nut. Tighten so the lock is
held up out of the way. Figure 22 (a). Lift and hook the
tank onto the fuel scale. With an empty LP tank, adjust
the fuel scale setting to E with scale setting (top) wing
nut. Figure 22 (b).
ƽCAUTION: Do not remove adjustment wing nut
from tank scale.
After adjusting tank scale, push tank down a couple of
times to check that the tank scale is set on “E”.
Figure 22
F
E
F
E
F
E
Tank lock
wing nut
(a) (b)
Scale setting
wing nut