weber FT 600 - Manual (Page 16)

16
Step 10
Add tank panel
You will need: tank panel assembly,
1/4-20 x 1 3/4 inch bolt, 1/4-20 hex nut, two 1/4 inch
nylon washers, pliers, and a 7/16 inch or adjustable
wrench.
Insert the tank panel tabs into the slots in the wheel
frame brace. Slide up until the notch at the bottom of
the tank panel fits over the cross brace of wheel frame.
Figure 13 (a).
Add the washer to the bolt. Put the bolt through panel
and cross brace. Add washer and hex nut and tighten
with 7/16 inch or adjustable wrench holding the nut
with the pliers. Figure 13 (b).
Figure 13
(a)
(b)
Slot in frame brace
Tabs on tank panel
Wheel frame
Cross brace
of wheel frame
Step 11
Add fuel scale
You will need: fuel scale assembly, two 1/4-20 wing
nuts and two nylon washers.
Slip the bolts on the back of the fuel scale assembly
through the two small holes in the tank panel. Make
sure indicator rod of fuel scale is on the left side of the
wheel frame.
Add washers, then wing nuts and tighten. Figure 14.
Figure 14
F
E
View from front left View from front right
F
E