Westinghouse SE 6000 - Manual (Page 62)

S ECTION 4: M ASTER F ILE E NTRY 4-11
Reader ID. Required. Enter the reader number to be linked to this access code (the reader
description is automatically displayed). The reader numbers can be entered in any order.
Time Code. Optional. Enter up to four time codes, in any order, that apply to this access
code (the time code parameters are displayed automatically). Default is 0 which is no access.
E
LEVATOR
D
EFINITION
[eleventr]
The elevator definition screen must be completed if the reader type is an elevator reader (reader
type 5). Perform the following steps:
1. When the Reader ID and Time Code fields have been entered in [acodentr], press F2 to
display the elevator definition screen [eleventr]—example below.
2. Enter the output contact IDs (usually wired to the elevator cab floor buttons) to be closed
(activated) when access is granted via this reader. Store each item (F6) after entry. Use F5
to move to the next output contact ID line.
[eleventr] Elevator Definition
Reader/Point Id
8004 = Contact 4
8006 = Contact 6
8008 = Contact 8
A
CCESS
G
ROUP
E
NTRY
[agdsentr], [agrpentr]
To facilitate assigning similar access privileges to large numbers of keyholders, the system allows
two or more access codes to be combined into an access group. Two screens are used: [agdsentr]
and [agrpentr]. Sample screens follow.
Access Group ID. Required. Enter a four-digit maximum access group number.
Tenant. Required (zoom available). Enter a four-digit maximum tenant number. Default is
tenant 0.
1
2