WatchGuard Technologies FireboxTM System 4.6 - Manual (Page 145)

User Guide 135
Configuring services to allow incoming RUVPN
3 Enter the username and password.
Firebox usernames are case sensitive.
4 To add the user to a group, select the group name in the Not Member Of list.
Click the left-pointing arrow.
Use pptp_users for Remote User PPTP and ipsec_users for Mobile User VPN. A given user can
be a member of both groups.
5 When you finish adding the user to groups, click Add.
The user is added to the Users list. The Setup Remote User dialog box remains open and cleared
so you can add another user.
6 Click Close to close the Setup Remote User dialog box.
The Firebox Users tab appears with a list of the newly configured user(s).
Configuring services to allow incoming RUVPN
Use the Firebox user groups (pptp_users and ipsec_users) to quickly configure the
allowed services for incoming RUVPN traffic. There are two recommended methods:
By individual service
Double-click each service that you want to enable for your remote VPN users. Set the
following properties on the service:
Incoming
- Enabled and allowed
- From: pptp_users or ipsec_users
- To: Any (or selected)
Outgoing
- Outgoing allowed
- From: Any (or selected)
- To: pptp_users or ipsec_users
Using the Any service
Add the Any service with the following properties:
Incoming
- Enabled and allowed
- From: pptp_users or ipsec_users
- To: Selected
Outgoing
- Enabled and allowed
Enable permissions for pptp_users if you are configuring Remote User PPTP.
Enable permissions for ipsec_users if you are configuring Mobile User VPN.