Cable assembly – Weider WESY39523 User Manual
Page 11
18.
Locate and open the parts bags labeled “CABLE
ASSEMBLY” and “PULLEYS.”
Lubricate the M10 x 165mm Bolt (30) with grease.
Attach the Swivel Cage (76) to the Swivel Carriage
(46) with the Bolt and an M10 Nylon Locknut (87).
Locate the Swivel High Cable (74), which is
3213mm long and has a ball on one end and a
threaded bolt on the other end. Wrap the Cable
around a 90mm Pulley (78). Attach two Pulleys to
the Swivel Cage (76) with two M10 x 45mm Bolts
(93) and two M10 Nylon Locknuts (87).
11
16. Press a 40mm x 50mm Inner Cap (21) into the Right
Butterfly Arm (26). Wet the lower end of the Arm and
a Long Pad (54) with soapy water. Slide the Pad onto
the Arm.
Attach a Press Handle (27) to the Right Butterfly
Arm (26) with two M8 x 20mm Button Head Screws
(51). Slide the Long Pad (54) down so that the bot-
tom is flush with the lower end of the Arm. Wet the
Press Handle with soapy water. Slide a Long
Handgrip (28) onto the Press Handle. Press a
25mm Round Inner Cap (29) into the Press Handle.
Lubricate an M10 x 50mm Bolt (100) with grease.
Attach a Pivot Bracket (70) to the Right Butterfly
Arm (26) with the Bolt and an M10 Nylon Locknut
(87). Do not overtighten the Nylon Locknut; the
Pivot Bracket must be able to pivot easily.
Repeat this step with the Left Butterfly Arm (25).
17. Lubricate an M10 x 80mm Button Head Bolt (104)
and both sides of two Plastic Washers (56) with
grease. Attach the Right Butterfly Arm (26) to the
Butterfly Frame (47) with the Bolt, the two Plastic
Washers, two Butterfly Caps (57), two M10 Washers
(91), and an M10 Nylon Locknut (87) as shown.
Make sure that the recessed sides of the Plastic
Washers are fitted over the welded bushing in the
Butterfly Arm. Do not overtighten the Locknut;
the Butterfly Arm must be able to pivot easily.
Repeat this step with the Left Butterfly Arm (25).
16
CABLE ASSEMBLY
74
18
78
78
87
93
76
87
17
IMPORTANT: Refer to the Cable Identification
Chart on page 26 for help identifying the
cables. Do not overtighten the bolts and
nuts attaching the pulleys. The pulleys must
be able to turn freely.
26
47
87
56
104
91
57
57
91
25
21
100
Lubricate
70
87
26
25
51
29
28
27
54
30
46