Weider WESY39523 - Manual (Page 20)

20
57. Press two 20mm x 40mm Inner Caps (116) and a
25mm x 40mm Square Inner Cap (117) into the
Seat Bracket (11).
Attach the Seat (16) to the Seat Bracket (11) with
two M6 x 16mm Screws (114), an M6 x 35mm
Screw (99), and an M6 Washer (97).
Turn the indicated Adjustment Handle (65) counter-
clockwise several turns to loosen it. Next, pull the
Handle and insert the Seat Bracket (11) into the
Seat Frame (8). Engage the Handle into one of the
holes in the Seat Bracket, and then turn the Handle
clockwise until it is tight.
58. Press two 20mm x 40mm Inner Caps (116) and a
25mm x 40mm Square Inner Cap (117) into the
Backrest Bracket (13).
Attach the Butterfly Backrest (15) to the Backrest
Bracket (13) with four M6 x 16mm Screws (114).
Turn the indicated Adjustment Handle (65) counter-
clockwise several turns to loosen it. Next, pull the
Handle and insert the Backrest Bracket (13) into the
Butterfly Upright (3). Engage the Handle into one of
the holes in the Backrest Bracket, and then turn the
Handle clockwise until it is tight.
59. Wet one end of the Squat Arm (32) with soapy
water. Slide a Short Pad (20) onto the Squat Arm
as shown.
Attach a Squat Handle (33) to the Squat Arm (32)
with two M8 x 20mm Button Head Screws (51).
Slide an Outer Cap w/Hole (111) onto the Squat
Handle and press it onto the end of the Squat Arm.
Wet the Squat Handle with soapy water. Slide an
200mm Handgrip (84) onto the Squat Handle.
Repeat this step with the other end of the Squat
Arm (32).
57
58
59
51
51
20
20
32
33
111
84
116
11
13
114
117
114
99
117
114
16
97
116
116
15
116
8
65
3
65
60
60. Attach the Squat Arm (32) to the Squat Bracket (37)
with two M10 x 65mm Carriage Bolts (110) and two
M10 Nylon Locknuts (87). Do not tighten the
Locknuts yet.
Finish attaching the Squat Arm (32) to the Squat
Bracket (37) with two M10 x 70mm Carriage Bolts
(106), two M10 Washers (91), and two M10 Nylon
Locknuts (87).
Tighten all of the M10 Nylon Locknuts (87) used
in this step.
87
32
110
37
91
91
106
87