Weider WESY39523 User Manual
Page 21
21
61
61. Turn the Squat Backrest (35) so that the four screw
holes are closer to the bottom of the Squat
Backrest than the top. Attach the Squat Backrest to
the Squat Bracket (37) with four M6 x 16mm
Screws (114).
Fully tighten the Adjustment Knob (115) into the
Squat Bracket (37). Turn the knob on the
Adjustment Knob counterclockwise several times to
loosen it. Next, pull the Knob and slide the Squat
Bracket (37) down onto the Squat Slider (38).
Engage the Knob into one of the holes in the Squat
Slider, and then turn the Knob clockwise until it is
tight.
62. Make sure that all parts have been properly tightened. The use of the remaining parts will be explained in
ADJUSTMENTS, beginning on the following page.
Before using the weight system, pull each cable a few times to make sure that the cables move smoothly
over the pulleys. If one of the cables does not move smoothly, find and correct the problem. IMPORTANT: If
the cables are not properly installed, they may be damaged when heavy weight is used. See the
CABLE DIAGRAMS on page 26 and 27 of this manual for proper cable routing. If there is any slack in
the cables, you will need to remove the slack by tightening the cables. See TROUBLESHOOTING on
page 25.
35
37
38
115
114
114