Weider WESY39523 - Manual (Page 15)

15
35
36
38
37
34. Remove the preattached 90mm Pulleys (78)
from the Double “U”-bracket (62).
Wrap the Butterfly Cable (69) under a 90mm Pulley
(78). Attach the Pulley to the Double “U”-bracket
(62) with an M10 x 45mm Bolt (93) and an M10
Nylon Locknut (87).
35. Wrap the Butterfly Cable (69) over a “V”-pulley (55).
Attach the Pulley and a Long Cable Trap (102) to
the other side of the bracket on the Butterfly Upright
(3) with an M10 x 60mm Bolt (59) and an M10
Nylon Locknut (87). Make sure that the Long
Cable Trap is turned to hold the Cable in the
groove of the Pulley.
36. Attach the Butterfly Cable (69) to the Pivot Bracket
(70) on the Right Butterfly Arm (26) with an M8 x
20mm Shoulder Bolt (103) and an M8 Nylon
Locknut (34).
37. Locate the Leg Lever Cable (75), which is
2505mm long and has an eyelet on one end and
a threaded pin on the other end. Route the eyelet
end of the Cable through the Seat Upright (9) and
attach it to the tab on the Leg Lever (10) with an
M8 x 20mm Shoulder Bolt (103) and an M8 Nylon
Locknut (34).
38. Attach a 90mm Pulley (78) inside of the Seat
Upright (9) with an M10 x 65mm Bolt (18), two M10
Washers (91), two 12mm Spacers (89), and an M10
Nylon Locknut (87), as shown.
69
55
69 103
59
102
87
75
78
87
18
9
89
89
91
91
3
34
75
10
9
103
70
26
34
34
69
78
87
62
93