Frame assembly – Weider WESY39523 User Manual
Page 6
1.
Locate and open the parts bags labeled “FRAME
ASSEMBLY 1” and “FRAME ASSEMBLY 2.”
See the inset drawing. Attach the Base Cap (24)
to the Short Base (2) with two M4 x 20mm Self-tap-
ping Screws (14) and two M4 Washers (120).
Press a 50mm Square Inner Cap (105) into the
open end of the Long Base (101).
Insert eight M10 x 65mm Carriage Bolts (110) up
through the Long Base (101) and the Short Base
(2) as shown. Note: It may be helpful to place
tape over the heads of the Carriage Bolts to
hold them in place.
Attach the Short Base (2) to the Long Base (101)
with two M10 x 70mm Bolts (85), the Long Frame
Plate (71), and two M10 Nylon Locknuts (87).
FRAME ASSEMBLY
6
Make sure that you understand all of the
information on page 5 before you begin
assembling the weight system.
1
85
87
105
101
71
2
87
2.
Press two 50mm x 75mm Inner Caps (58) into the
Foot Plate (53). Attach the Foot Plate to the Long
Base (101) with two M10 x 65mm Carriage Bolts
(110) and two M10 Nylon Locknuts (87).
3.
Attach the tether on the Long Pin w/Tether (112) to
the Long Base (101) with an M4 x 20mm Self-tap-
ping Screw (14).
Attach the four Knee Rest Bumpers (108) to the
Squat Knee Rest (41) with four M4 x 20mm Self-
tapping Screws (14). Attach the Squat Knee Rest to
the Long Base (101) with an M10 x 85mm Bolt (96)
and an M10 Nylon Locknut (87). Do not overtight-
en the Locknut; the Squat Knee Rest must be
able to pivot.
3
101
112
87
14
96
41
108
108
108
14
14
110
110
110
110
2
2
87
87
58
58
110
53
101
14
120
24