Whirlpool 15080000 - Manual (Page 16)

Document ID:15080000 Rev: E Technical Support: 800-626-6912 Page 16 of 20
Crystal Clean
™
Pipe-Free
®
Spa - Operating Instructions
Preparing the Pedicure Spa for Operation:
After the pedicure spa is installed and the plumbing and electrical connections are made, clean and disinfect
the basin before initial use. Rinse the basin by using the attached w ater sprayer. Wipe the basin dry with a
clean tow el.
To Operate the Pedicure Spa, Follow These Easy Steps:
Adding Water to the Pedicure Spa Basin:
1. Close the drain by turning the chrome drain handle counter-clockw ise until it stops.
2. Add w ater to the basin by lifting upw ard on the w ater faucet fill handle. Turn the handle in a counter-
clockw ise direction for cold w ater or clockw ise for warm w ater as indicated by the red (hot) and blue
(cold) markings around the handle ( CAUTION: hot w ater can burn skin). Continue to add w ater until the
top of the fill line is reached. The fill line is indicated by the w avy (~~~~) line in the basin.
3. Turn the w ater off by pushing the handle dow nward and center.
Operating the Crystal Clean ™ Pipe-Free ® System:
The Crystal Clean ™ Pipe-Free ® System eliminates pipes and traditional style jets that can harbor harmful
bacteria w hile at the same time delivering a soothing, quality foot massage. This unique system is driven by
an impeller that pulls w ater through the inlet cover and then forces the water outward through key massage
zones in the footplate. The end result is a soothing massage delivered to all areas of the foot: front, back
and bottom.
To start or stop the w hirlpool, depress the On\Off button w ith finger (not fingernail) (NOTE: An indicator
light on the “Jets” button flashes when the footplate is improperly installed, or the basin contains no
water. As a result, the whirlpool will not function. To fix, simply check that the footplate is securely
fastened or add water to the basin).
Removing Water from the Pedicure Spa Basin:
First, make certain the w hirlpool jets are turned off by pressing the On/Off switch. The impeller motor w ill quit
running w hen in the “Off” position.
Open the drain by turning the drain handle in a clockw ise direction until it stops, the drain plunger w ill open
and drain pump w ill start to operate. The w ater level w ill low er as water is pumped out of the basin. Turn the
pump off by turning the drain handle in a counter-clockw ise direction once the basin is fully drained (NOTE:
the PDP will automatically shut off after 2-1/2 minutes. We recommend turning off the pump
manually if all water has drained before automatic shut-off).
Warning:
It is extremely important to follow the cleaning instructions located on the following page. Failure to
clean the pedicure spa adequately can result in serious health issues for your clients as well as the
nail technician. Failing to clean your pedicure spa may also cause the pedicure spa to not work
properly. Please consult your local and state codes concerning pedicure chair cleaning for further
requirements. Failure to follow local and state codes may result in monetary fines.