Operating sequence – Zanussi ZWF 385 User Manual

Page 14

Advertising
background image

14

Operating sequence

Load the laundry

Open the door by

carefully pulling the

door handle outwards.

Place the laundry in

the drum, one item at

a time, shaking them

out as much as

possible. Close the door.
Measure out the detergent and the fabric

softener

Pull out the dispenser drawer until it stops.

Measure out the amount of detergent required,

pour it into the main wash compartment

and, if you wish to carry out a programme with

the prewash, pour it into the compartment

marked .

If required, pour fabric softener into the

compartment marked

(the amount used

must not exceed the «MAX» mark in the

drawer). Close the drawer gently.
Select the required programme by means of

the programme selector dial

(1)

Turn the programme selector dial to the

required programme.

The green light of button

6

starts to flash.

It can be turned either clockwise or

anticlockwise.
On position «O» the programme is reset and

the machine is switched OFF.

At the end of the programme the selector

dial must be turned to position «O», to

switch the machine off.

ATTENTION!

If you turn the programme selector dial to

another programme when the machine is

working, the red pilot light of button will flash 3

times to indicate a wrong selection. The

machine will not perform the new selected

programme.
Select the required temperature by means

of the temperature selector dial

(2)

Turn the programme selector dial to the

required temperature. It is possible to select a

temperature from 95°C to Cold.

For the maximum temperature allowed by

each programme, refer to the section

«Programmes table».
Select the spin speed or Rinse Hold option

by pressing button

3

The relevant light will light up.

When selecting a programme, the light

corresponding to the maximum speed allowed

for that programme will illuminate (refer to the

section «Programme table» for the maximum

allowed spin speed).
Select the desired option by means of

buttons

4

and

5

Depending on the programme, different

functions can be combined. These must be

selected after choosing the desired programme

and before pressing the button

6

.

For the compatibility of the options with the

washing programmes, refer to the section

«Programme table».

132970080gb.qxd 13/02/2008 13.43 Page 14

Advertising