Zanussi ZWF 385 - Manual (Page 15)

15
Start the programme by pressing button 6
To start the selected programme, press this
button; the corresponding green pilot light
stops flashing.
On programme progress display the pilot light
A illuminates to indicate that the appliance
starts operating and the door is locked.
IMPORTANT!
If an option which is not compatible with the set
wash programme is selected, the red light of
this button flashes for 3 times.
Altering an option or a running programme
It is possible to change any option before the
programme carries it out.
Before you make any change, you must pause
the washing machine by pressing the button 6 .
Changing a running programme is possible
only by resetting it. Turn the programme
selector dial to «O» and then to the new
programme position. Start the new programme
by depressing the button 6 again.
The washing water in the tub will not empty
out.
Interrupting a programme
Press the button
6 to interrupt a programme
which is running, the corresponding light starts
to flash. Press the button again to restart the
programme.
Cancelling a programme
Turn the selector dial to «O» to cancel a
programme which is running. Now you can
select a new programme.
Opening the door after the programme has
started
First set the machine to pause by pressing the
button 6 .
After some minutes, the door can be opened.
If the machine is already heating, that the
water level is above the bottom edge of the
door, the door cannot be opened.
If you cannot open the door but you need to
open it you have to switch the machine off by
turning the selector dial to «O». After few
minutes the door can be opened
(Pay attention to the water level and
temperature!).
After this procedure, it will be necessary to set
the programme and the options again and then
press the button 6 .
At the end of the programme
The machine stops automatically.
The pilot light of button 6 goes off while the
phase light C illuminates. The door can be
opened.
If at the end of a programme there is water in
the tub, to empty out the water follow the
following instructions:
●
turn the programme selector dial to «O»
●
select the «Drain» or «Spin» programme
●
reduce the spin speed if needed, by means
of the relevant button
●
press button 6
At the end of the cycle, turn the programme
selector dial to «O» to switch the machine off.
Remove the laundry from the drum and
carefully check that the drum is empty.
If you do not intend to carry out another wash,
close the water tap.
Leave the door open to prevent the formation
of mildew and unpleasant smells.
132970080gb.qxd 13/02/2008 13.43 Page 15