Zanussi ZWF 385 - Manual (Page 24)

If necessary, check the
setting with a spirit
level.
Water inlet
An inlet hose is supplied and can been found
inside the machine drum.
Do not use the hose from your previous
machine to connect to the water supply.
1. Open the porthole and extract the inlet
hose.
2.Connect the hose
with the angled
connection to the
machine.
Attention !
Do not place the inlet hose downwards.
Angle the hose to the left or right depending
on the position of your water tap.
3. Set the hose correctly by loosening the ring
nut. After positioning the inlet hose, be sure to
tighten the ring nut again to prevent leaks.
4.Connect the hose to
a tap with a 3/4”
thread. Always use
the hose supplied
with the appliance.
The inlet hose must not be lengthened. If it is
too short and you do not wish to move the tap,
you will have to purchase a new, longer hose
specially designed for this type of use.
45°
35°
Water drainage
The end of the drain hose can be positioned in
three ways:
Hooked over the
edge of a sink using
the plastic hose
guide supplied with
the machine. In this
case, make sure the
end cannot come
unhooked when the
machine is emptying. This could be done by
tying it to the tap with a piece of string or
attaching it to the wall.
In a sink drain pipe branch. This branch must
be above the trap so that the bend is at least
60 cm above the ground.
Directly into a drain pipe at a height of not
less than 60 cm and not more than 90 cm. The
end of the drain hose must always be
ventilated, i.e. the inside diameter of the drain
pipe must be larger than the outside diameter
of the drain hose.
The drain hose must not be kinked.
Electrical connection
This machine is designed to operate on a 230
V, single-phase, 50 Hz supply.
Check that your domestic electrical installation
can take the maximum load required (2.2 kW),
also taking into account any other appliances
in use.
24
132970080gb.qxd 13/02/2008 13.44 Page 24