ZyXEL Communications NBG-419N - Manual (Page 113)

Chapter 11 Wireless LAN
NBG-419N User’s Guide
113
11.9 WPS Station Screen
Use this screen when you want to add a wireless station using WPS. To open this
screen, click Network > Wireless LAN > WPS Station tab.
Note: Note: After you click Push Button on this screen, you have to press a similar
button in the wireless station utility within 2 minutes. To add the second wireless
station, you have to press these buttons on both device and the wireless station
again after the first 2 minutes.
Figure 75 Network > Wireless LAN > WPS Station
The following table describes the labels in this screen.
Apply Click Apply to save your changes back to the NBG-419N.
Refresh Click Refresh to get this screen information afresh.
Table 43 Network > Wireless LAN > WPS
LABEL DESCRIPTION
Table 44 Network > Wireless LAN > WPS Station
LABEL DESCRIPTION
Push Button Use this button when you use the PBC (Push Button Configuration)
method to configure wireless stations’s wireless settings. See
Section
10.3.1 on page 90 .
Click this to start WPS-aware wireless station scanning and the wireless
security information synchronization.
Or input
station’s PIN
number Use this button when you use the PIN Configuration method to
configure wireless station’s wireless settings. See
Section 10.3.2 on
page 91 .
Type the same PIN number generated in the wireless station’s utility.
Then click Start to associate to each other and perform the wireless
security information synchronization.