ZyXEL Communications NBG-419N - Manual (Page 214)

Chapter 30 Sys OP Mode
NBG-419N User’s Guide
214
Table 78 Maintenance > Sys OP Mode
Note: If you select the incorrect System Operation Mode you may not be able to
connect to the Internet.
LABEL DESCRIPTION
System Operation Mode
Router
Select Router Mode if your device routes traffic between a local network
and another network such as the Internet. This mode offers services such
as a firewall or bandwidth management.
If you select Router Mode the following pop-up message window
appears.
You can configure the IP address settings on your WAN port. Contact your
ISP or system administrator for more information on appropriate settings.
Access Point Select Access Point Mode if your device bridges traffic between clients
on the same network.
If you select Access Point Mode the following pop-up message window
appears.
• In Access Point mode all Ethernet ports have the same IP address.
• All ports on the rear panel of the device are LAN ports, including the
port labeled WAN. There is no WAN port.
• The DHCP server on your device is disabled.
• The IP address of the device on the local network is set to 192.168.1.2.
WISP Mode Select WISP Mode if your device needs a wireless client to connect to an
existing access point.
If you select WISP Mode the following pop-up message window appears..
• You cannot configure Wireless LAN settings (including WPS) and
scheduling in the WISP mode.
• The IP address of the device on the local network is the same as the IP
address given to the NBG-419N while in router mode (default is
192.168.1.1).
Apply Click Apply to save your settings.
Reset Click Reset to return your settings to the default (Router)