Printing a test card – Zebra Technologies P100iTM User Manual
Page 38
34
P100i User’s Manual
980590-001 Rev. A
P100i Printer Setup
Printing a Test Card
Printing a Test Card
With Ribbon Cartridge and Card Cleaning Cartridge loaded, your P100i Printer is ready to
print. To check the operation of the printer, you should print a test card.
1.
Place the printer power switch in the OFF (O) position.
2.
While holding down the Multi-Function Control Button, place the printer power switch in
the ON ( | ) position. The LCD status window will glow blue.
3.
Keep pressing the Multi-Function Control Button until you are prompted to insert a card.
4.
Insert a card into the card entry slot. At this point, you can release the Multi-Function
Control Button.
5.
A test card will print after a few seconds and then exit the printer.
P100i
Serial Nr: 060376
Firmware: V1.50
Head resistance: 1568
Offset: X002 - Y015
EC: 0014
Printing Counter: 00002716
Multi-
Function
Control
Button
Power
Switch