ZyXEL Communications ZyXEL Dimension GS-3012F - Manual (Page 195)

Dimension GS-3012F Gigabit Ethernet Switch
Introduction to CLI 28-21
Table 28-4 Command Summary: config-vlan Commands
COMMAND DESCRIPTION
<ip-address>
<mask>
manageable
Allows the switch to be managed using
this specified IP address.
<ip-address>
<mask> Sets the IP address and subnet mask of
the switch in the specified VLAN for
packet loopback test.
28.9.5 interface Commands
The following commands are listed in configuration mode as “interface” switch commands; all are preceded with
the command
interface.
Table 28-5 Command Summary: Interface
COMMAND DESCRIPTION
interface
<port-
list>
Enables a port or a list of ports
for configuration.
bandwidth-limit Enables bandwidth limit on the
switch.
bandwidth-limit
egress
<Mbps> Sets the maximum bandwidth
allowed for outgoing traffic on the
switch.
bandwidth-limit
ingress
<Mbps> Sets the maximum bandwidth
allowed for incoming traffic on
the switch.
broadcast-limit Enables broadcast storm control
limit on the switch.
broadcast-limit <pkt/s> Sets how many broadcast
packets the interface receives
per second.
multicast-limit Enables the interface multicast
limit.
multicast-limit <pkt/s> Sets how many multicast packets
the interface receives per
second.
dlf-limit Enables the Destination Lookup
Failure (DLF) limit.
dlf-limit <pkt/s> Sets the interface DLF limit in
packets per second (pps).
spq Sets the interface to use Strict
Priority Queuing.
wrr Sets the interface to use
Weighted Round Robin queuing
(WRR).