Xilinx ML310 - Manual (Page 64)

64 www.xilinx.com ML310 User Guide
1-800-255-7778 UG068 (v1.01) August 25, 2004
Chapter 2: ML310 Embedded Development Platform R
•
1 single-ended clock at 2.5V
•
1 pin not connected
Adapter Board PM Connectors
Tyco Z-Dok+ adapter board connectors, part number 1367555-1 are the receptacle
connectors on the personality modules that mate to the ML310 Tyco Z-Dok+ host board
connectors, part number 1367550-5. The Tyco data sheet for part number 1367555-1 is
available at
http://www.z-dok.com/documents/1367555.pdf .
On the adapter board connectors, located on the personality module, each signal pair has
a pair of ground pins on the opposite side of the open space, as shown in
Figure 2-22 . The
signal pairs alternate from side to side along the length of the open space. All of the "B" and
"E" pins are two contacts tied together and grounded on the personality module. The "A",
"C", "D", and "F" pins are signal pins.
ML310 PM Utility Pins
Contact Order
The Z-Dok+ power and ground pins contact in the following order:
•
1 and 6;
•
then 2 and 5;
•
then 3 and 4
Figure 2-22: Adapter Board Connector Pin Detail
B1 C2 C1 B3 C4 C3
A2 A1 B2 A4 A3 B4
E1 F2 F1 E3 F4 F3
D2 D1 E2 D4 D3 E4
Plastic Housing
Copper Pins