Cancel self test – Zebra Technologies Z6Mplus User Manual
Page 114
96
Z4Mplus/Z6Mplus User Guide
13163L Rev. 3 5/20/2004
Troubleshooting
Printer Diagnostics
CANCEL Self Test
This self test prints a listing of the configuration parameters currently stored in the printer’s
memory. See
. Depending on the options ordered, your label may look different.
Figure 40 • Sample Configuration Labels
The configuration shown on the label may be changed either temporarily (for specific label
formats or ribbon and label stock) or permanently (by saving the new parameters in memory).
See
Basic Configuration on page 53
for further information about the configuration procedure.
To perform the CANCEL Self Test, complete these steps:
1.
Turn the printer Off (
O
).
2.
Press and hold
CANCEL
while turning On (
l
) the printer.
3.
Release
CANCEL
after the DATA light turns off (approximately five seconds).