Zebra Technologies Z6Mplus - Manual (Page 62)

44 Z4Mplus/Z6Mplus User Guide 13163L Rev. 3 5/20/2004
Printer Operation
Print a Configuration Label
4. Did the configuration label print correctly?
If the label... Then...
Printed correctly 1. Go to Configuration on page 49 .
Did not print or is aligned
improperly 1. Review the following items in the order shown. Do
only as many steps as needed to solve the printing
problem.
• Review Types of Media on page 15 to make sure that
you have the correct type of media for your
application.
• Review Ribbon on page 17 . If you are using direct
thermal media, you do not need to use ribbon. If you
are using thermal media, ribbon is required for
printing.
• Review Load Roll Media on page 25 or Load Fanfold
Media on page 38 .
• Configure the printer according to the directions given
in Basic Configuration on page 53 .
• Check the position of the media sensor and move if
necessary. Follow the directions in Position the Label
Sensor on page 84 .