Feed and pause self test, Communication diagnostics test – Zebra Technologies Z6Mplus User Manual
Page 117
Troubleshooting
Printer Diagnostics
13163L Rev. 3 5/20/2004
Z4Mplus/Z6Mplus User Guide
99
FEED and PAUSE Self Test
Performing this self test temporarily resets the printer configuration to the factory default
values. These values are active only until power is turned off unless you save them
permanently in memory.
To perform a FEED and PAUSE self test, complete these steps:
1.
Turn Off (
O
) the printer.
2.
Press and hold
FEED
and
PAUSE
while turning the power On (I). Hold
FEED
and
PAUSE
until the
DATA
light turns off.
No labels print at the end of this test.
Communication Diagnostics Test
This test is controlled from the front panel display (see
Setting Communication Diagnostics
). A typical printout from this test is shown in
. Turn the printer Off
(
O
) to exit this self test.
Figure 43 • Communication Diagnostics Test Printout
Note •
This label prints upside-down.