Yamaha RX-Z11 - Manual (Page 104)

Graphical user interface (GUI) menu
104
En
■ Parametric EQ (Parametric equalizer)
Use this feature to adjust the parametric equalizer of each speaker.
PEQ Data Copy (Parametric equalizer data copy)
Use this feature to copy the result data of the automatic setup to the
manual configuration area. You can select the parametric equalizer
type applied to the copied result data of the automatic setup. See
page 50 for the descriptions of each parametric equalizer type.
PEQ Select (Parametric equalizer type select)
Use this feature to select the parametric equalizer type that applied
to the results of the automatic setup. See page 50 for the
descriptions of each parametric equalizer type.
• When you carry out the automatic setup, this unit automatically set “PEQ
Select” to “Natural”.
• “Speaker Level” settings (see page 102) also changes corresponding to the
setting of “PEQ Select”.
• This unit does not change the configurations of “Manual” even if you
perform the automatic setup.
Manual parametric equalizer configuration of each
speaker
Use this feature to adjust the tonal quality of each speaker. You can
copy the results of the automatic setup for the base of the manual
configuration by using “PEQ Data Copy”. Set “PEQ Select” to
“Manual” in advanced.
1
Press 9k / n / l / h to select “Test Tone” or the
speaker you want to adjust.
Test Tone
Use this feature to select whether to turn on or off the test tone
output while you are adjusting the tonal quality of each
speaker.
2
Press 9h to access the settings window.
3
Press 9k / n / l / h to select “PARAM” and then
press 9
ENTER to select a parameter from “Band”
(band), “Freq.” (frequency) or “Q” (Q factor).
y
You can adjust “Gain” (gain) with any parameter.
Choice Descriptions
Flat
→ Manual
Copies the result of the automatic setup that the “Flat”
type parametric equalizer is applied to.
Front
→ Manual
Manual Copies the result of the automatic setup that the
“Front” type parametric equalizer is applied to.
Natural
→ Manual Copies the result of the automatic setup that the
“Natural” type parametric equalizer is applied to.
Choice Descriptions
Manual Applies the manually configured parametric equalizer in
“Manual Setup”.
Flat Applies the “Flat” type parametric equalizer.
Front Applies the “Front” type parametric equalizer.
Natural Applies the “Natural” type parametric equalizer.
Through Does not use the parametric equalizer.
Notes
Dynamic Range
S-Wave Control
Parametric EQ
Tone Control
Lipsync
Subwoofer L
Subwoofer R
Test Tone
PEQ Data Copy
PEQ Select
Choice Adjusted speaker
Front L Front left speaker
Front R Front right speaker
Center Center speaker
Surround L Surround left speaker
Surround R Surround right speaker
Surround Back L Surround back left speaker
Surround Back R Surround back right speaker
Front Presence L Front presence left speaker
Front Presence R Front presence right speaker
Rear Presence L Rear presence left speaker
Rear Presence R Rear presence right speaker
Subwoofer L Subwoofer left
Subwoofer R Subwoofer right
Choice Functions
On Outputs the test tone.
Off Does not output the test tone.
PEQ Data Copy
PEQ Select
Front L
Front R
Center
PARAM RESET
EDIT EXIT
Band/Gain