Yamaha RX-Z11 - Manual (Page 41)

Connections
41
En
Prepara
tion
Both FM and AM indoor antennas are supplied with this unit.
Connect each antenna correctly to the designated terminals. In
general, these antennas should provide sufficient signal strength.
• The AM loop antenna should be placed away from this unit.
• The AM loop antenna should always be connected, even if an outdoor AM
antenna is connected to this unit.
• A properly installed outdoor antenna provides clearer reception than an
indoor one. If you experience poor reception quality, install an outdoor
antenna. Consult the nearest authorized Yamaha dealer or service center
about outdoor antennas.
Connecting the wire of the AM loop antenna
y
The wire of the AM loop antenna does not have any polarity and you can
connect either end of the wire to AM or GND terminal.
Assembling the supplied AM loop antenna
■ Connecting the HD Radio antennas
(U.S.A. model only)
This unit is equipped with two FM and AM antenna terminals.
Connect the supplied AM loop antenna for the HD Radio tuning to
the ANTENNA-1 AM and GND terminals, and the supplied AM
loop antenna for the conventional AM tuning to the ANTENNA-2
AM and GND terminals. And also, connect the supplied indoor FM
antennas to the ANTENNA-1 and ANTENNA-2 FM terminals.
y
You can select whether this unit tune to the conventional FM and AM
stations or HD Radio FM and AM stations by selecting “HD Radio” or
“TUNER” in “Input Select” (see page 96) and in “Manual Setup” (see
page 110).
Assembling the supplied AM loop antenna
(For HD Radio tuning, U.S.A. model only)
Connecting the wire of the AM loop antenna
Connecting the FM and AM antennas
Note for U.S.A. customers
When you use the FM/AM tuning feature in the main zone only,
connect the supplied indoor FM antenna and AM loop antenna to
the AMTENNA-1 terminals only. Refer to the right column.
Notes
GND AM FM
ANTENNA-2
Ground (GND terminal)
For maximum safety and minimum interference, connect the
antenna GND terminal to a good earth ground. A good earth
ground is a metal stake driven into moist earth.
Outdoor AM antenna
Use a 5 to 10 m (16 to 32 ft)
vinyl-covered wire extended
outdoors from a window.
Indoor FM
antenna
(supplied)
AM loop
antenna
(supplied)
(U.S.A. model)
Open the lever Insert Close the lever
ANTENNA-1
HD-Radio
GND
AM
FM
AM loop antenna
(supplied)
Ground (GND terminal)
For maximum safety and minimum interference, connect the
antenna GND terminal to a good earth ground. A good earth
ground is a metal stake driven into moist earth.
Outdoor AM antenna
Use a 5 to 10 m (16 to 32 ft)
vinyl-covered wire extended
outdoors from a window.
Indoor FM antenna
(supplied)
(U.S.A. model)
Press and hold Insert Release