Yamaha RX-Z11 - Manual (Page 131)

Remote control features
131
En
Ad
v
a
nce
d
Op
eratio
n
5
Press G
SETUP again to exit from the setup mode.
■ Clearing a learned function (ERASE)
1
Press G
SETUP using a ballpoint pen or similar
object.
“SETUP” appears in the display window (4).
2
Press 9k / n repeatedly to select “ERASE” and then
press 9
ENTER.
The remote control enters the learning mode. “ERASE” and
the name of the currently selected control area appears in the
display window (4) alternately.
3
Set the operation mode selector to F
SOURCE and
then press an input selector button (3).
“ERASE” and the name of the selected control area appears in
the display window (4) alternately.
y
• You can also select the desired control area by pressing 5SELECT
l / h repeatedly.
• If you want to erase the function learned in the AMP or TV control
area, set the operation mode selector to FAMP or FTV.
4
Press 9
ENTER.
“E-KEY” appears in the display window (4).
5
Press and hold the button you want to clear for about
3 seconds.
If clearing is successful, “ERASE” and “OK” appears in the
display window (4).
y
• If you continuously want to clear another function, repeat step 3.
• Once you clear a learned function, the button reverts to the factory
setting (or to the manufacturer setting if you have set remote control
codes).
6
Press G
SETUP again to exit from the setup mode.
• “NG” appears in the display window (4) on the remote control if clearing
was unsuccessful.
• “ERROR” appears in the display window (4) if you press more than one
button simultaneously.
Notes
SETUP
ERASE DVD
E-KEY
ERASE OK