York DJ150 - Manual (Page 5)

035-19046-002-B-0104
Unitary Products Group 5
REFERENCE
Additional information is available in the following reference
forms:
• Technical Guide - DJ150, 036-21484-002
• General Installation - DJ150, 035-19046-002
• Pre-start & Post-start Check List - 035-18466-000
• Economizer Accessory -
Downflow Factory Installed, 035-18286-000
Downflow Field Installed, 035-18285-000
Horizontal Field Installed, 035-18287-000
• Motorized Outdoor Air Damper 035-18283-000
• Manual Outdoor Air Damper (0-100%) 035-18282-000
• Manual Outdoor Air Damper (0-35%) 035-18281-000
• Gas Heat Propane Conversion Kit 035-17374-000
• Gas Heat High Altitude Kit (Natural Gas) 035-17282-000
• Gas Heat High Altitude Kit (Propane) 035-17281-000
• –60 ° F Gas Heat Kit 035-18216-000
• Electric Heater Accessory 035-17291-001
• Unit Renewal Parts List 035-19085-000
All forms referenced in this instruction may be ordered from:
Standard Register
Toll Free Fax: (877) 379-7920
Toll Free Phone: (877) 318-9675
RENEWAL PARTS
Refer to York’s USER’S MAINTENANCE and SERVICE
INFORMATION MANUAL Part Number 035-19047-001.
APPROVALS
Design certified by CSA as follows:
1. For use as a cooling only unit, cooling unit with supple-
mental electric heat or a forced air furnace.
2. For outdoor installation only.
3. For installation on combustible material and may be
installed directly on combustible flooring or, in the U.S.,
on wood flooring or Class A, Class B or Class C roof cov-
ering materials.
4. For use with natural gas (convertible to LP with kit).
The installer should pay particular attention to the words:
NOTE, CAUTION, and WARNING. NOTES are intended to
clarify or make the installation easier. CAUTIONS are given
to prevent equipment damage. WARNINGS are given to alert
installer that personal injury and/or equipment damage may
result if installation procedure is not handled properly.
This product must be installed in strict compliance
with the enclosed installation instructions and any
applicable local, state, and national codes including,
but not limited to, building, electrical, and mechanical
codes.
Incorrect installation may create a condition where the
operation of the product could cause personal injury
or property damage.