Z Microsystems 21 - Manual (Page 10)

Doc# 27-0017UM Issued 08/03 Rev 1.0
10
INSTALLATION
FINAL ADJUSTMENTS
Slide the Glider partially
out.
Use a flathead screw-
driver to slightly move
the Z-Locks in toward or
out from the Glider,
depnding on the need for
best fit. While holding
the Z-Locks at the
proper setting, tighten
the screws on the Z-
Lock mounts. Go to the rear of the
cabinet to tighten the
slider extender rail
scews. If there is not
enough room to work at
the back of the cabinet,
the Glider may need to
be removed to tighten
the rail screws.
The Glider should now
slide in and out
smoothly. If not, repeat
these steps.
Because of variances in
cabinet frames, there
may need to be some
adjustments of the
Glider slide system for
best fit and movement
of the Glider in and out.
If the Glider binds when
rolling in and out,
perform the following
procedures. Slide the Glider in and
out several times. The
Glider should slide in and
out easily.
INSTALLATION TEST
The Glider should slide
in and out easily. If not,
adjust the position of the
two Z-Locks again.
The Glider should easily
close completely.