Z Microsystems 21 - Manual (Page 7)

Doc# 27-0017UM Issued 08/03 Rev 1.0
7
INSTALLATION
SLIDE REMOVAL
With the Glider laid on a
workbench, press down
to release the Z-Locks
on each side of the front
of the Glider to slide the
side rails back. The slide rails will reach
a stop about half way
back.
This is a safety stop to
prevent the Glider from
sliding out too far while
mounted in the rack.
Simultaneously press in
the safety catches on
each slide rail and slide
the side rails all the way
off the back of the Glider. The slides should now
be separated from the
Glider.