Yamaha H11 - Manual (Page 50)

H11 Owner’s Manual
50
ENGLISH
Keyboard Stand Assembly
3.
Attach B.
3-1
Align the holes on A with those on B and hold A
and B together.
3-2
Finger-tighten six short screws (6
×20 mm) start-
ing with the top hole.
3-3
Tighten the screws securely.
4.
Attach C.
4-1
Align the holes on A with those on C and hold A
and C together.
4-2
Finger-tighten four short screws (6
×20 mm)
starting with the top hole.
4-3
Tighten the screws securely.
5.
Assemble the pedal structure.
5-1
Pass the pedal cord (that comes out from the rear
of pedal box E) through a hole on the bracket of
D, then pass it through the pipe.
5-2
Align the holes on the bottom of E with the holes
on the bracket of D, then attach E and D by tight-
ening six small screws (4
×6 mm). At this time,
first tighten the two center screws, then tighten
the rest of the screws.
5-3
Pull the end of the pedal cord to eliminate any
slack inside the bracket on D.
CAUTION
Hold E securely to avoid slippage.
A
B
A
B
C
A A
D D
E E
D D
E E