ZyXEL Communications Omni TA128 - Manual (Page 134)

122
Connect DTE Speed :
Error Control Level :
Protocol Link Speed :
Octets Received : 0
Octets Sent : 0
Cause :
Cause Value : 0
HDLC FCS Error : 0
HDLC Receive Over-run : 0
HDLC Transmit Under-run : 0
Output Parameter Output Value Description
Connect DTE Speed Current on-line DTE speed.
Error Control Level Error control protocol used for current
session.
Protocol Link Speed Current on-line DCE speed, line speed.
Octets Received Number of data octets received from
remote.
Octets Sent Number of data octets sent to remote.
Cause Verbose disconnection reason for the last
session.
Cause Value Numerical disconnection reason for the
last session.
HDLC FCS Error Errors in frame (block) checksum (If there
were many FCS Errors, you may have
experienced problems on the line).
HDLC Transmit
Under-run For TA's processor power measurement.
HDLC Receive
Over-run For TA's processor power measurement.
Extended "AT&" Command Set
Command Options Function & Description Ref.