ZyXEL Communications Omni TA128 - Manual (Page 25)

13
3
Configuring Your ISDN
Line and Network
The set up procedure for the TA128 needs to be done only once.
The settings will be stored in non-volatile RAM. The only time you
will need to reconfigure your line is when you perform a hardware
reset on your TA or when you change options on your ISDN line.
There is a simple Windows 3.x, NT4.0 or 95 utility provided by
ZyXEL to help you set-up the TA128. We will explain how to
setup your switch using a Windows/Windows 95 utility which
comes with the TA128.
If your TA128 is not going to be set up by a computer running
Windows, you will need some type of terminal program that allows
you to send AT commands to the TA and receive responses from
the TA.
Configuring Your TA using a Configuration
Utility
Along with your TA128, you will find a disk labeled “ZyXEL
ISDN Configuration Manager”. Complete the following steps to
install this software:
1. Insert your ZyXEL Configuration Utility disk into the floppy
drive on your computer
2. From Windows 3.x choose Run... from the File menu.
3. From Windows NT4.0 choose Run... from the File menu.
4. From Windows 95 choose Run... from the Start menu.
5. Type: A:\setup.exe and press Enter.
6. Follow the instructions on your screen.