ZyXEL Communications GS-3012 - Manual (Page 144)

Dimension GS-3012 Gigabit Ethernet Switch
20-4 Policy Rule
Table 20-1 Policy
LABEL DESCRIPTION
Outgoing Select Send the packet to the mirror port to sent the packet to the mirror port.
Select Send the packet to the egress port to send the packet to the egress port.
Select Send the matching frames (broadcast or DLF, multicast, marked for dropping or to be
sent to the CPU) to the egress port to send the broadcast, multicast, DLF, marked-to-drop or
CPU frames to the egress port.
Select Set the packet’s VLANID to set the VLAN ID of the packet with the value you configure in
the VLANID field.
Metering Select Enable to activate bandwidth limitation on the traffic flow(s) then set the actions to be taken
on out-of-profile packets.
Out of Profile
Action Select the action(s) to be performed for out-of-profile traffic.
Select Drop the packet to discard the out-of-profile traffic.
Select Change the DSCP Value to replace the DSCP field with the value specified in the Out of
profile DSCP field.
Select Do not drop the matching frame previously marked for dropping to queue the frames
that are marked to be dropped.
Add Click Add to inset the entry to the summary table below.
Cancel Click Cancel to reset the fields back to your previous configuration.
Clear Click Clear to set the above fields back to the factory defaults.
20.3 Viewing and Editing Policy Configuration
To view a summary of the classifier configuration, scroll down to the summary table at the bottom of the Policy
screen. To change the settings of a rule, click a number in the Index field.
Figure 20-2 Policy: Summary Table
The following table describes the labels in this screen.
Table 20-2 Policy: Summary Table
LABEL DESCRIPTION
Index This field displays the policy index number. Click an index number to edit the policy.
Active This field displays Yes when policy is activated and No when is it deactivated.
Name This field displays the descriptive name for this policy. This is for identification purposes only.
Classifier(s) This field displays the name(s) of the classifier to which this policy applies.