ZyXEL Communications GS-3012 - Manual (Page 179)

Dimension GS-3012 Gigabit Ethernet Switch
Introduction to CLI 28-7
Table 28-2 Command Summary: Enable Mode
COMMAND DESCRIPTION
help Displays help information.
logout Exits Enable (or privileged) mode.
exit Exits Enable (or privileged) mode.
history Displays a list of command(s) that you
have previously executed.
enable Accesses Enable (or privileged) mode.
disable Exits Enable (or privileged) mode.
configure Accesses Configuration mode.
no logging Clears the system log.
arp Flushes the ARP (Address Resolution
Protocol) table.
interface <port-
number>
Clears the interface status of the
specified port(s).
show
ip Displays IP related information.
ip arp Displays the ARP table.
ip route Displays IP routing information.
ip route static Displays IP static route information.
hardware-monitor
<C|F>
Displays current hardware monitor
information with the specified
temperature unit (Celsius C or Fahrenheit
F).
system-information Displays general system information.
vlan1q gvrp Displays GVRP setting.
port-isolation Displays port isolation setting.
spanning-tree config Displays Spanning Tree Protocol (STP)
settings.
mac address-table
static
Displays static MAC address table.
address-table
<all>
<mac|vid|port> Displays MAC address table.
You can sort by MAC address, VID or
port.
lacp Displays Link Aggregation Control
Protocol information.
trunk Displays link aggregation information.
radius-server Displays RADIUS server settings.
port-access-
authenticator
Displays all port authentication settings.