ZyXEL Communications Intelligent Broadband Sharing Gateway P-324 - Manual (Page 110)

Prestige 324 Intelligent Broadband Sharing Gateway
Remote Node Setup 9-13
9.5.2 Traffic Redirect Setup
Configure parameters that determine when the Prestige will forward WAN traffic to the backup gateway
using Menu 11.6 — Traffic Redirect Setup.
Figure 9-10 Menu 11.6 — Traffic Redirect Setup
Table 9-6 Traffic Redirect Setup
FIELD DESCRIPTION EXAMPLE
Active Press [SPACE BAR] and select Yes (to enable) or No (to disable) traffic
redirect setup. The default is No.
When the Active field is Yes, you must configure every field in this screen
unless you are using PPPoE or PPTP encapsulation (except Check WAN
IP Address and Timeout).
If you don’t configure these fields and are using PPTP or PPPoE
encapsulation, then the Prestige checks the PPPoE channel or PPTP
tunnel to determine if the WAN connection is down.
Yes
Configuration:
Backup
Gateway IP
Address Enter the IP address of your backup gateway in dotted decimal notation.
The Prestige automatically forwards traffic to this IP address if the
Prestige’s Internet connection terminates.
0.0.0.0
Metric Enter a number from 1 to 15 to set this route’s priority among the
Prestige’s routes (see Route Priority and Metric on page 9-11) The
smaller the number, the higher priority the route has. 15
(default)
Menu 11.6 - Traffic Redirect Setup
Active=
Yes
Configuration:
Backup Gateway IP Address= 0.0.0.0
Metric= 15
Check WAN IP Address= 0.0.0.0
Fail Tolerance= 2
Period (sec)= 5
Timeout (sec)= 3
Press ENTER to Confirm or ESC to Cancel:
Press Space Bar to Toggle.