ZyXEL Communications Intelligent Broadband Sharing Gateway P-324 - Manual (Page 35)

2-2 Hardware Installation & Initial Setup
Table 2-1Prestige Rear Panel Connections
CONNECTION DESCRIPTION AND FUNCTION
Power 9V AC Connect the included power adaptor to the power supply and connect the other end of
the power adaptor cable to this socket.
Do this step last. Use only the included power adapter!
See the Power Adapter Specification Appendix for regional
specifications.
Power 9V AC Connect the end of the included power adaptor (use only this adapter) to this power
socket.
Use only the included power adapter! See the Power Adapter
Specification Appendix for regional specifications.
CON/AUX
switch
CON/AUX port Set this switch to the “CON” side to use the CON/AUX port as a regular console port for
local device configuration and management. Connect the 9-pin male end of the console
cable to the console port of the Prestige and the other end (choice of 9-pin or 25-pin,
depending on your computer) end to a serial port (COM1, COM2 or other COM port) of
your computer. You can use an extension RS-232 cable if the enclosed one is too short.
Your computer should have a terminal emulation communications program (such as
HyperTerminal) set to VT100 terminal emulation, no parity, 8 data bits, 1 stop bit, no data
flow and 9600 bps port speed.
Set this switch to the “AUX” side to use the CON/AUX port as an auxiliary dial-up WAN
connection. Connect the 9-pin male end of the RS-232 Y-cable to the CON/AUX port and
use the included CON/AUX converter on the other 9-pin end of the cable to connect to a
modem or TA.